Features

The RC-FS10 Remote Communicator creates a virtual radio/simple dispatcher on a Windows^®-based PC. It allows you to remote access IDAS™ NXDN™ repeaters via an IP network and communicate with IDAS™ NXDN™ radio terminals even from outside of the radio coverage area.

The RC-FS10 can be used not only for an IDAS™ NXDN™ trunking system, but also an IDAS™ NXDN™ conventional system*.

*

To use the RC-FS10 in an IDAS trunking system, either the UC-FR5000 #03 (for trunking system) or the UC-FR5000 #02 (for conventional system) is required to be installed in the IC-FR5000/FR6000 repeater.

Options

• CT-23 connects HM-152 or SM-26 microphone audio (RJ-45 jack) and PTT/Monitor signals to the 3.5mm stereo jack for connection with a PC. A stereo jack cable is supplied with the CT-23. AC adapter, BC-147SA/SE is required separately.
• The digital voice converter, CT-24, is a USB connection device which converts microphone audio to an IDAS™ NXDN™ compatible digital signal. The remote communicator software will not work if the CT-24 is not connected.

CT-23 Microphone Adapter	BC-147SA/SE AC Adapter	SM-26 Desktop Microphone	HM-152 Hand Microphone

Specifications

SYSTEM REQUIREMENTS
Operating system	Windows® XP SP3 or later (32-bit) Windows Vista® SP2 or later (32-bit/64-bit), Windows® 7 (32-bit/64-bit)
CPU	Intel® Pentium® 4 1.6GHz CPU or better
Memory	512MB or higher (for Windows® XP) 1GB or higher (for Windows Vista® and Windows® 7)
Hard disk space	100MB of disk space
Audio	DirectSound compatible audio (Frequency response up to 20kHz, sampling rate 48kHz)
Display resolution	1024x768 pixel or more
Other	CD-ROM drive, USB 2.0 port, 10Mbps or faster Ethernet interface, speaker, microphone or headset

·

All stated specifications are subject to change without notice or obligation.

·

Microsoft Windows and Windows Vista are either registered trademarks or trademarks of Microsoft Corporation in the United States and/or other countries. Intel and Pentium are trademarks of Intel Corporation in the U.S. and other countries.