IC-9100

photo
zoombrochure (PDF)Manual (PDF)

General

Frequency coverage*1 Rx
0.030–60.000MHz*2 136.000–174.000MHz*2
420.000–480.000MHz*2 1240.000–1320.000MHz*2*3

Tx
1.800–1.999MHz 3.500–3.999MHz
5.255–5.405MHz*2 7.000–7.300MHz
10.100–10.150MHz 14.000–14.350MHz
18.068–18.168MHz 21.000–21.450MHz
24.890–24.990MHz 28.000–29.700MHz
50.000–54.000MHz 144.000–148.000MHz
430.000–450.000MHz 1240.000–1300.000MHz*3
Mode USB, LSB, CW, RTTY(FSK), FM, AM*4,
DV(with UT-121)
Number of channels 396 Ch*5 (99 Ch for each HF/50, 144, 430/440, 1200MHz band)
4 Call Ch*5 (1 Ch for each band)
24 Scan edges*5 (6 Ch for each band)
20 satellite and 50 GPS memories
Antenna connector HF/50MHz: SO-239(50Ω)×2
144MHz: SO-239(50Ω)
430/440MHz: Type-N(50Ω)
1200MHz: Type-N(50Ω) (With UX-9100)
Power supply requirement 13.8V DC ±15%
Temperature range 0°C to +50°C; +32°F to +122°F
Frequency stability Less than ±0.5ppm (0°C to +50°C)
Dimensions (W×H×D)
(projections not included)		 315×116×343 mm;
12.4×4.57×13.5 in
Weight (approx.) IC-9100: 11kg; 24.3lb
UX-9100: 950g; 2.1lb
*1 Showing USA version, frequency coverage depends on version.
*2 Some frequency ranges are not guaranteed.
*3 With optional UX-9100
*4 Transmit HF/50MHz only. Cannot receive on 1200MHz band.
*5 With optional UX-9100.

Transmitter

Output power SSB/CW/RTTY/FM/DV*1
HF/50MHz: 2–100W
144MHz: 2–100W
440MHz: 2–75W
1200MHz*2: 1–10W

AM
HF/50MHz: 2–30W
Modulation system SSB:
Digital PSN modulation

AM:
Digital Low power modulation

FM:
Digital Phase modulation

DV (With UT-121)
GMSK Digital Phase modulation
Spurious emission
(Unwanted emission)		 1.8–29.7MHz: Less than -50dB
50,144MHz: Less than -63dB
430/440MHz: Less than -61.8dB
1200MHz: Less than -53dB (With UX-9100)
Carrier suppression More than 40dB
Unwanted sideband suppression More than 55dB

1200MHz: More than 40dB (With UX-9100)
Microphone impedance 600Ω (8-pin connector)
*1 With UT-121
*2 With UX-9100

Receiver

Intermediate frequencies HF/50MHz: 64.455MHz, 36kHz
144MHz: 10.850MHz, 36kHz
430/440MHz: 71.250MHz, 36kHz
1200MHz (With UX-9100): 243.950MHz, 10.950MHz, 36kHz
Sensitivity SSB/CW (10dB S/N)
1.8–29.9MHz: 0.16μV*1
50–54MHz: 0.13μV*2
144/440MHz: 0.11μV
1200MHz*3: 0.11μV

AM (10dB S/N)
0.5–1.8MHz: 12.6μV*1
1.8–29.9MHz: 2.0μV*1
50–54MHz: 1.6μV*2
144/440MHz: 1.4μV

FM (12dB SINAD)
28 –29.7MHz: 0.5μV*1
50–54MHz: 0.32μV*2
144/440MHz: 0.18μV
1200MHz*3: 0.18μV

DV*4(1% BER)
28–29.7MHz: 1.0μV*1
50–54MHz: 0.63μV*2
144/440MHz: 0.35μV
1200MHz*3: 0.35μV
Squelch sensitivity
(threshold)		 FM
HF: 0.3μV*1
50MHz: 0.3μV*2
144MHz: 0.18μV
440MHz: 0.18μV
1200MHz*3: 0.18μV

SSB
HF: 5.6μV*1
50MHz: 5.6μV*2
144MHz: 1.0μV
440MHz: 1.0μV
1200MHz*3: 1.0μV
Selectivity SSB (BW: 2.4kHz, sharp)
More than 2.4kHz / –6dB
Less than 3.4kHz / –40dB

CW (BW: 500Hz, sharp)
More than 500Hz / –6dB
Less than 700Hz / –40dB

RTTY (BW: 500Hz, sharp)
More than 500Hz / –6dB
Less than 800Hz / –40dB

AM (BW: 6kHz)
More than 6.0kHz / –6dB
Less than 10.0kHz / –40dB

FM (BW: 15kHz)
More than 12.0kHz / –6dB
Less than 22.0kHz / –40dB

DV (with UT-121)
More than –50dB (12.5kHz spacing)


1200MHz (With UX-9100):
SSB, CW
More than 2.3kHz / –6dB

FM
More than 15.0kHz / –6dB
Spurious and image rejection ratio HF/50MHz: More than 70dB*5
144, 430/440MHz: More than 60dB
1200MHz: More than 50dB (With UX-9100)
Audio output power
(at 13.8V DC)		 More than 2.0W at 10% distortion with an 8Ω load
EXT SP connector 2-conductor 3.5 (d) mm (1⁄4″) /8Ω
*1 Preamp-1 ON
*2 Preamp-2 ON
*3 With UX-9100
*4 With UT-121
*5 Except IF Through points on 50MHz band.


All stated specifications are subject to change without notice or obligation.
Top of Page