 |
|
   |
The 100 Ch/Sec Wideband Signal “Search Machine”
100kHz–1309.995MHz* wideband coverage
While the IC-R6 receives an ultra wideband frequency
range, the radio provides superior sensitivity and
receiver characteristics that is insusceptible to
interference. Amateur stations, AM, FM, short wave
broadcasts, TV audio* and a variety of utility
communications can be caught and listened to.
* Frequency range depends on version. Analog TV audio
only. Cannot decode digital TV audio.
100 channels per second high speed scan
The IC-R6 has 100 channels per second high speed
scan capability*. This superior scanning power allows
the utmost efficiency when searching over 1300MHz of
spectrum!
* VFO mode scanning.
15 hours of continuous receive capability*
The IC-R6 is energy-efficient, designed to provide many
hours of listening enjoyment on a single charge. With the
supplied rechargeable Ni-MH cells (1400mAh ×2), the
IC-R6 provides up to 15 hours of continuous receive
capability*.
* At 50mW output using external speaker.
1300 memory channels with 22 memory banks
With 1300 alphanumeric memory channels, 50 scan edges and 200 auto write memories, the IC-R6 gives you flexible scanning. Use the bank link scan feature to choose from and connect any of the 22 memory banks.
VSC (Voice Squelch Control)
The VSC opens the squelch only when a modulated signal is detected and ignores unmodulated beat noise. It is a handy feature for those listeners who are scanning for talk, news and music, but not data bursts or beacons.
Multiple power choices
The IC-R6 can be powered by rechargeable Ni-MH cells, or with alkaline batteries. Run the IC-R6 using the AC adapter, BC-196S, or opt for a cigarette lighter cable, CP-18. When used the optional drop-in charger stand BC-194 with the AC adapter or cigarette lighter cable, you can easily start charging the Ni-MH cells, while eliminating the need to connect the power source to the DC power jack of the receiver.
Other features
- Built-in audio low pass filter
- ±1.0ppm high frequency stability (at 25°C)
- Earphone cord antenna for AM aviation as well as
FM broadcast
- Ferrite bar antenna for AM broadcast
- 150mW loud audio with internal speaker
- DTCS and CTCSS tone squelch and reverse tone
squelch
- Priority watch function with priority beep function
- Optional CT-17, CI-V level converter for remote control
- PC programmable with optional CS-R6
- Receiver-to-receiver cloning (optional OPC-474
required)
- Auto power OFF (0.5–2 hours and end of busy signal)
- Compact, drip-resistant construction
- Duplex operation monitoring
- Automatic LCD backlight
- Dial speed acceleration
- Built-in RF attenuator
- Auto memory write scan stores the detected frequency,
mode and tone into a specified memory
- Reversible up/down buttons and dial knob for volume,
frequency, memory channel, scan direction
and set mode settings
- Optional new tube earphone, SP-27
- Weather channel receive with weather alert*