Firmware Updates / Software Downloads

Transceiver

Model name IC-7300
Download Type Firmware
Version Version 1.20
Update 2017/11/30
Note

Changes in this version

  • A combination of [MIC] and [USB] is now selectable as a modulation signal input in the SET MODE item "DATA OFF MOD" and "DATA MOD".
  • English, German and French are now selectable for the Full Keyboard in the new SET MODE item "Full Keyboard Layout".
  • Updated ESP version 70MHz band frequency range to 70.15-70.25MHz.
  • Other performance improvements and bug fixes.

To update the firmware

  • Thoroughly read Section 8. USING AN SD CARD and Section 15.
    UPDATING THE FIRMWARE of the FULL MANUAL and follow the instructions appeared on the display of the IC-7300.
  • The firmware will be updated to the following versions.
    Main CPU: 1.20
    DSP Program: 1.07
    DSP Data: 1.00
    FPGA: 1.13
File Type zip
File Size 2.67MB
Manual IC-7300

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous