Firmware Updates / Software Downloads

Transceiver

Model name IC-7610
Download Type Firmware
Version Version 1.11
Update 2018/07/30
Notes

Changes in this version

  • Fixed an issue where the format of the Scope waveform data (CI-V Command: 27 00) output from the USB is incorrect in firmware version 1.10.

To update the firmware

  • To updated from firmware version 1.05 or older to 1.11, the IC-7610 needs to have firmware version 1.06 installed.
  • Thoroughly read Section 6, SD CARD/USB FLASH DRIVE, in the BASIC MANUAL and the Section 13, UPDATING THE FIRMWARE, in the ADVANCED MANUAL, and follow the instructions displayed on the IC-7610 LCD screen.
  • BE SURE to make a backup copy of your data settings to an SD card/USB flash drive before updating the firmware.
  • The firmware will be updated to the following versions.
    Main CPU: 1.11
    Sub CPU: 1.03
    Front CPU: 1.01
    FPGA: 1.05
File Type ZIP
File Size 7.57MB
Manual IC-7610

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous