Firmware Updates / Software Downloads

Option

Model name RS-BA1
Download Type Control software
Version Version 1.60
Update 2014/03/26
Note

Improvements

  1. Compatible with the IC-7700 version 2.00 or later firmware.
  2. Improved to prevent voice skip when a network delay and/or high packet loss occurs.
  3. Improved to prevent voice delay.

Note

  • When you use the RS-BA1 with a USB 3.0 device, you must use a USB 3.0 driver. Download the driver here.
  • RC-28 firmware version 1.01 or later is required for the RC-28. Download the firmware here.
  • When you update the control software:
    1. Download and expand the Rsba1_up_ver160.zip.
    2. Double-click Update.exe to start the software update.
    3. Follow the instructions displayed on the screen.
  • You must have a previous version of the RS-BA1 software installed BEFORE you can update to version 1.60.

CAUTION

  • The Recover_Setup_Rsba1.reg file is included in the Rsba1_up_ver160.zip. Execute the Recover_Setup_Rsba1.reg file ONLY if you need to reinitialize the RS-BA1's settings.
File Type ZIP
File Size 51.8MB
Manual RS-BA1

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous