Firmware Updates / Software Downloads

Transceiver

Model name CS-7100
Download Type Cloning software
Version Revision 1.10
Update 2015/05/21
Note

Improvements

[CI-V Output (for ANT)] setting item is added to output the status such as frequency and so on to the antenna controller from the [REMOTE] jack and the [USB] connector.

Refer to CS-7100 Update information— Revision 1.10 for details.


Note

  • You must have the CS-7100 cloning software installed BEFORE you update to revision 1.10.
  • Install the Release E4 version of the IC-7100 firmware to use the added feature in CS-7100 Revision 1.10. Download the firmware here.
  • CS-7100 Revision 1.10 can read icf files that are made by Revision 1.01 or earlier.
  • The latest USB driver (version 1.20) is not included in the CS-7100 revision 1.10 file. To use a USB 3.0 device, download the necessary USB 3.0 compatible driver here.
File Type ZIP
File Size 4.94MB

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous