HOME > Support > Firmware Updates / Software Downloads > IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500

Firmware Updates / Software Downloads

Communications Receiver

Model name IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500
Download Type Firmware
Version Ver.2.10
Update 2006/07/13
Note Major improved function,-
  • Priority scan for IC-R2500's controller operation
  • In P25 mode operation
  • Stanby beep function DV mode operation
  • Please read "Software & Firmwareupdate information" (3.45MB) thoroughly and make sure what is required for the firmware update.
  • When your receiver is already connected to the PC and it work normally, the USB driver is not necessary to update. If you would like to update the USB driver with new one, you have to delete the previous USB driver in your PC then you should install the new USB driver.
  • Never turn off the receiver power while the updating is being performed.
  • Save the setting data and memory data of your receiver before performing the software and firmware update.
  • Control software (Ver. 2.10) and firmware software (Ver. 2.10) must be updated at the same time when the receiver software is updated.
File Type ZIP
File Size 743KB
Manual IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.