HOME > Support > Firmware Updates / Software Downloads > IP1000C (100 terminal versions #11 and #12)

Firmware Updates / Software Downloads


Model name IP1000C (100 terminal versions #11 and #12)
Download Type Firmware
Version Version 1.64
Update 2016/10/05

This firmware update fixes the following problems.

  • The IP100H could not always reply to a call from the VE-PG3 (converter mode) if the PTT on the IP100H was pressed immediately after receiving a call.
  • The IP100H could lose reception audio during Full-Duplex operation, even with a short network interruption.
  • The IP100H made unintended beeps while roaming (changing the access point).


  • The IP1000C Version 1.64 automatically updates the IP100Hs to Version 1.62 when the Automatic Update setting is Enabled. [Default]
File Type ZIP
File Size 3.83MB
Manual IP1000C

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.