Firmware Updates / Software Downloads


Model name RS-AP3
Download Type Software update
Version Version 2.14
Update 2016/05/27


[RS-AP3 software]
Added “Optimized for Stable Communication 1” and “Optimized for Stable Communication 2” settings in the Rate setting.

[Updated the embedded Access Point firmware]
- AP-90M Version 2.10

Opening the Setup.exe file will start installation.

After setting the access points, remove the USB flash drive.

The flash drive must be inserted into the USB port when:
- installing the RS-AP3.
- starting the RS-AP3 for the first time.
- saving or opening a setting file.
- synchronizing with the mirroring function.

File Type ZIP
File Size 15.0MB

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.