Firmware Updates / Software Downloads

Option

Model name RS-BA1 Version 2
Download Type Control software
Version Version 2.10
Update 2019/01/25
Note

Changes in this version

  • The IC-9700 is now supported. (Single mode/Single scope screen operation.)

To update the software

  • Execute the Update.exe extracted from the downloaded file on the PC that has an older RS-BA1 Version 2 installed. Then follow the instructions displayed on the screen.
  • The software will be updated to the following versions.
    Remote control: Version 2.10
    Remote utility: Version 2.11

Notes

  • You cannot upgrade from RS-BA1 (Version 1.**) to RS-BA1 Version 2, with this software update.
  • The driver for USB 3.0 is downloadable here.
  • The firmware for the RC-28 is downloadable here.
  • Use the 'Recover_Setup_Rsba1_Control.reg' and 'Recover_Setup_Utility.reg' extracted registry files ONLY when you need to initialize the settings of the RS-BA1 Version 2.
File Type ZIP
File Size 24.22MB
Manual RS-BA1 Version 2

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous