Firmware Updates / Software Downloads

Transceiver

Model name IC-7610
Download Type Firmware
Version Version 1.05
Update 2018/01/31
Notes

Changes in this version

  • The FPGA's firmware is improved.
    The transmit signal quality (unwanted sideband suppression ratio) in the SSB mode is improved.
    The receiver IF filter in the AM mode is improved.
    The COMP meter accuracy is improved.

To update the firmware

  • Thoroughly read Section 6. SD CARD/USB FLASH DRIVE of the BASIC MANUAL and the Section 13. UPDATING THE FIRMWARE of the ADVANCED MANUAL and follow the instructions displayed on the IC-7610.
  • Be sure to make a backup copy of your data settings to an SD card/USB flash drive before installing the firmware update.
  • The firmware will be updated to the following versions.
    Main CPU: 1.05
    Sub CPU: 1.01
    Front CPU: 1.00
    FPGA: 1.04
File Type ZIP
File Size 7.58MB
Manual IC-7610

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous