Firmware Updates / Software Downloads | Support

Transceiver

Model name	IC-7800
Download Type	Firmware
Version	Ver.1.22
Update	2006/01/05
Note	Instruction manual (2files) Firmware update information (V120E) pdf (1.38MB) IC-7800 Instruction Manual Addendum (V120E) pdf (10.9MB) Please save the setting data of IC-7800 to CF card before starting firmware update. Never cut off power supply while updating firmware. Before starting download, please read Firmware update information (V110E) pdf (2.75MB) carefully and make sure what is required for firmware update. Firmware update using LAN needs the Firmware update utility VER.1.0 ZIP (256KB) Please download this software, too. This firmware (Ver.1.22) is compatible with all versions of the IC-7800. NOTE:Crossover cable or Patch cable is required for updating. Control Software OS;Windows^®98/98SE/ME/2000/XP Windows^® 95 and NT are not supported. Major points of update from Ver.1.10 to Ver.1.22* Modification of adjusting software for factory use. AFC and NET functions for the PSK decoder (newly added function) FFT scope averaging function for both PSK and RTTY decoder (newly added function) Color setting for FFT scope waveform for both PSK and RTTY decoder (newly added function) Improved SSB transmission passband width setting Meter response selection for standard and edgewise meters (newly added function) Subdivided variable steps for both APF and CW pitch Ver.1.20 and Ver1.22 is the same regarding the function and performance because this software was upgraded for changing software adjustment method in our factory. Therefore, we deleted Ver1.20 when we upload Ver1.22 as this is unnecessary.
File Type	ZIP
File Size	3.55MB
Manual	IC-7800

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.

Top of Page