HOME > Support > Firmware Updates / Software Downloads > IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500

Firmware Updates / Software Downloads

Communications Receiver

Model name IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500
Download Type Firmware
Version Ver.2.10
Update 2013/10/01
Note

Read this information carefully before clicking the "Agree" button below to download the firmware.

Improvement

  1. P25 frequency coverage is extended.
  2. The AFC function is improved.

Note

  • Read "Software & Firmware update information" thoroughly and make sure what is required.
  • Before installing this firmware, you must first delete the previous USB driver on your PC, and then install the latest USB driver. The USB driver is included in the receiver control software.
  • Version 2.10 firmware must be used with version 2.201 of the receiver control software. Download the control software version here.
  • Save the receiver's setting and memory data BEFORE starting the update. In addition, never turn off the receiver power or disconnect the USB cable during the update.

Procedure

You need to update your receiver's firmware to version 2.10, do the following steps.

  1. Backup your data.
  2. Delete the previous USB driver.
  3. Download and install the USB driver and then version 2.201 of the control software.
  4. Download and install version 2.10 of the receiver firmware.
File Type ZIP
File Size 743KB
Manual IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous
Top of Page