HOME > Support > Firmware Updates / Software Downloads > IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500

Firmware Updates / Software Downloads

Communications Receiver

Model name IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500
Download Type Control software
Version Ver.2.20
Update 2011/06/15
Note

Major points of the Ver. 2.20 update.

  1. Both control software (Ver. 2.20) and USB device driver (Ver. 1.10), support Microsoft® Windows® 7(32/64bit).
  2. Took countermeasure for the issue of “no response from control software and PC seems to be hang up”, when you turn on both of “USB Audio” and “Confirmation Beep” of Control software at Windows® 7, and click any place in the virtual control panel in PC screen.
  3. Added manual selection of COM port and USB audio port.
    Note:
  • When update the control software to Ver.2.20, the current PCR receiver firmware version should be Ver.2.10. If the firmware version in your receiver is not Ver.2.10, please first update the firmware to Ver.2.10.
  • Please read "Control software update information" thoroughly and make sure of what is required for the updating.
    Refer to the USB driver installation instructions written in “USB driver installation guide” and install the USB driver.
  • Never turn off the receiver power while the updating is being performed.
  • The software (Ver.2.20) is for Windows® XP, Windows Vista® and Windows® 7 only, if you require to the software and USB driver for Windows® 98SE/Me/2000, please use previous version’s Ver.2.11.
  • Save the setting data and memory data of your receiver before performing the software and firmware update.
File Type ZIP
File Size 7.34MB
Manual IC-R1500 / IC-PCR1500 / IC-R2500 / IC-PCR2500

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous