HOME > Support > Firmware Updates / Software Downloads >ID-51A PLUS2, ID-51E PLUS2

Firmware Updates / Software Downloads

Transceiver

Model name ID-51A PLUS2
ID-51E PLUS2
Download Type Firmware
Version Release E3
Update 2019/12/13
Note

Changes from Release E2

  • Fixed the problem where the call-ending frame may not be sent when transmitting the D-PRS DV-A or NMEA DV-G position data in the DV mode using Release E1 or Release E2 firmware.

Release E3 fixes the following problems.

  • The call-ending frame was not sent after releasing PTT. This caused a delay in sounding the standby beep from the receiving transceiver.
  • The repeater does not stop transmitting the downlink soon after the transceiver finishes transmitting the uplink.

To update the firmware

  • Thoroughly read "Firmware update instructions" and follow the instructions in it.
  • An OPC-2350LU or OPC-2218LU is required to install the firmware update. To use the OPC-2218LU for the first time, a USB driver is required. Download the driver here.
  • Making a backup file of programmed contents and settings before updating the firmware is recommended.

  • The DSP firmware will be updated to 1.04.
File Type ZIP
File Size 1.53MB
Manual ID-51A PLUS2, ID-51E PLUS2

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous