Firmware Updates / Software Downloads

Option

Model name RS-BA1
Download Type Control software
Version Version 1.41
Update 2013/08/01
Note

Improvement

  1. USB 3.0 is now supported.

Note

  • When you use the RS-BA1 version 1.41, the USB driver must be the USB 3.0 compatible version. Download the USB driver here.
  • When you use the RS-BA1 version 1.41, the RC-28 firmware must be updated at the same time to the user that RC-28 is used. Download the latest firmware version here.
  • When you update the control software:
     1. Download and expand the "Rsba1_up_ver141.zip".
     2. Double-click "Update.exe" to start up the software update.
     3. Follow the instructions displayed on the screen.
  • You must have the RS-BA1 software installed BEFORE you update to revision 1.41.

CAUTION

  • Only execute the "Recover_Setup_Rsba1.reg" file when you need to reinitialize the RS-BA1's settings.
File Type ZIP
File Size 22.7MB

Regarding this Download Service.

When using this download service, the implementation, use and/or results of use are the sole responsibility of the person making the download.

Firmware is important data for the basic system control of your equipment. An interruption during downloading or a malfunction may cause a failure in the data re-writing, and your equipment may stop functioning normally. If such a failure of the firmware re-writing results in your equipment not functioning normally, Icom Inc. expressly denies and is free from any and all responsibility arising from the result of damage from such an event.

I fully understand the above, and agree not to hold Icom Inc. responsible for any damage to my equipment operation or loss of data as a result of this download.




Previous